ProSoft Technology MVI46-PDPMV1 - Manual (Page 16)

Start Here MVI46-PDPMV1 ♦ SLC Platform
User Manual PROFIBUS DPV1 Master
Page 16 of 160 ProSoft Technology, Inc.
March 25, 2011
1.5 Installing the Module in the Rack
If you have not already installed and configured your SLC processor and power
supply, please do so before installing the MVI46-PDPMV1 module. Refer to your
Rockwell Automation product documentation for installation instructions.
Warning: You must follow all safety instructions when installing this or any other electronic
devices. Failure to follow safety procedures could result in damage to hardware or data, or even
serious injury or death to personnel. Refer to the documentation for each device you plan to
connect to verify that suitable safety procedures are in place before installing or servicing the
device.
After you have checked the placement of the jumpers, insert MVI46-PDPMV1
into the SLC™ chassis. Use the same technique recommended by Rockwell
Automation to remove and install SLC™ modules.
Warning: This module is not hot-swappable! Always remove power from the rack before
inserting or removing this module, or damage may result to the module, the processor, or other
connected devices.
1 Turn power OFF.
2 Align the module with the top and bottom guides, and slide it into the rack
until the module is firmly against the backplane connector.
3 With a firm but steady push, snap the module into place.