PLANET MH-2300 - Manual (Page 8)

8
2.2.1 Deploying MH-2300 in Gateway mode
The unit is deployed to replace your existing firewall.
Step 1. Configure the LAN settings: (according to your network infrastructure).
 Physical Connection: Select “Port1 (LAN 1)”.
 Interface Type: Select “LAN”.
 Connection Type: Select “NAT Routing”.
 Specify the IPv4 Address and Netmask.
Configuring the LAN Interface Settings
Note
The access to the management interface is subject to the LAN
interface. Therefore, enter the management address to a Web
browser correspondingly if any changes have been made to the
LAN interface.