PLANET MH-2300 - Manual (Page 16)

16
Step 8. Connect MH-2300’s Port 5 (WAN 1) to your LAN switch or hub and
remove the connection on Port 1 (LAN 1).
The Network Address Settings for Non-inline Mode
Note
The access to MH-2300 is now available through the WAN 1 port
only. Therefore, use the address specified for the WAN interface to
access the management interface.
Step 9. Under Network > Interface Group, set as shown below:
 Select “Group 1” for Port 1 (LAN 1) and Port 5 (WAN 1).
 Click OK.
Grouping the Network Interfaces