PLANET IPX-2100 - Manual (Page 74)

Internet Telephony PBX System
IPX-2100
74
Blind Transfer Allow unattended or blind transfers. It works like this: While on a
conversation with A, you dial the blind transfer key sequence. The
system says "Transfer" then gives you a dial tone, while A is on hold.
You dial the transferee number (B's number) and A is put through to
B immediately. Your line is off. The caller ID displayed to B is exactly
the same as the caller ID presented to you.
Attended Transfer Allow attended transfer or supervised transfer. It works like this:
While on conversation with A, you dial the Attended Transfer key
sequence. The system says "Transfer" then gives you a dial tone,
while A is on hold. You dial the transferee number (B's number) and
talk with B to introduce the call, then you can hang up and A will be
connected with B. In case B does not want to answer the call, he/she
simply hangs up and you will be back to your original conversation.
Disconnect Call Disconnect the current transfer call (for Attended transfer).
Timeout for answer on
attended transfer（sec）
Set the timeout value
One Touch Recording Configure the function key for One Touch Recording
Call Forward Enable/Disable Call Forward and the settings of function keys for
different forward modes.
Do Not Disturb Enable/Disable “Do Not Disturb”
Spy Configure the function keys for spy modes.
Blacklist Add/Delete blacklisted number.
Voicemail Configure the function keys for entering voicemail and check
extension voicemail.
Invite Participant In conference, the administrator can invite people into the
conference by dialing “0”. After pressing “0”, you will get dial tone,
and you can dial to invite people. After the call is connected, please
press ** to direct the people into the conference, or *# to hang up the
current call and return to the conference.
Create Conference During the call, you can dial *0 to forward to the conference with the
callee.
Return to conference with
participant
In conference, the administrator can dial “0” to invite people into the
conference. After pressing “0”, you will get dial tone, and you can dial
to invite the participant; when the call is connected, dial “**” to return
to the conference with invited participant.
Return to conference
without participant
In conference, the administrator can dial “0” to invite people into the
conference. After pressing “0”, you will get dial tone, and you can dial