PLANET ICA-E5550V - Manual

3. If necessary, insert a memory card with the metallic contacts facing
down into the card slot of the camera.
4. Install Cable Gland with RJ45 cable.
A. Disassemble the cable gland as shown below:
B. Slip the clamping nut through the Ethernet cable. (Ethernet cable
is not included)
VERIFY THE CONTENTS INSIDE THE BOX
The package should contain the following items. If any item is missing
or damaged, please contact the seller immediately.
 Camera x 1
 Quick Installation Guide x 1
 Mounting Screw Kit x 1
 Cable Gland x 2
 Terminal Block x 1
 Screw Torx x 1
 Mounting Diagram x 1
Prior Installation Hardware Overview
C. Wrap around the cable with the sealing insert with claw.

D. Attach the cable gland body to the hole of the camera.
Step 1: Installation
1. Loosen the three screws securing the dome cover.
Note
To avoid scratches or leaving fingerprints on the dome
cover, it is recommended to retain the plastic covering
the dome cover until the camera is completely installed.
However, the plastic has been removed on the pictures
in this documentation to show clarity of the procedures
being described.
2. Carefully lift to open the dome cover and place it by the side of the
camera.

Note
Do not abruptly lift the dome cover; it is attached to the
camera with a spring wire.