PLANET CAM-IVP55 User Manual
Safety precautions, Package contents, Overview

– 1 –
– 2 –
– 3 –
– 4 –
1. Safety Precautions
1. Please do not directly touch the sensor element. If
necessary, use a soft cloth moistened with alcohol to
wipe off any dust.
2. Please be extra careful not to shake the camera.
3. Please avoid places where there is direct sunlight.
4. When the camera is not in use, keep the lens or the lens
cap attached to protect the sensor.
5. Don’t attempt to service this unit yourself unless you are
authorized to do so. This may exposure you to dangerous
voltage or other hazards. Refer all servicing to qualified
personnel only.
6. Please don’t use the camera under the following
abominable environments. Temperature is lower than
-10 degrees Centigrade, or is higher than +50 degrees
Centigrade.
2. Package Contents
CAM-IVP55 / CAM-IVP55V
1 x Quick Installation Guide
1 x Wrench
1 x Waterproof Cable Connector
1 x Screw Kit
3. Overview
Power Input
Video Output
Connector Definition
Connector
Description
Power Input
Connect to a DC 12V power adapter.
Video Output
BNC connector for analog video output.
4. Product Specification
General
Model
CAM-IVP55
CAM-IVP55V
Image pick-up device 1/3" Color Sony Exview HAD CCD II
Effective Pixels
NTSC: 976 x 494, PAL: 976 x 582
Horizontal Resolution
Color: 650 TVL, B / W: 700 TVL
Lens
Board Lens 3.6mm
Vari-Focal Lens with ICR
3.7~12mm / F1.6
Min. Illuminator
0.01 Lux ([email protected]) Day Mode
Auto Electronic Shutter NTSC: 1/60s~1/100,000s, PAL: 1/50s~1/110,000s
S/N Ratio
More than 48 dB
Gamma Characteristic 0.45
White Balance
Auto / Indoor / Outdoor / Manual / Push Auto
Gain Control
Auto
Back Light Comp.
On / Off
Synchronous System
Internal
Video Output
Composite 1.0 Vp-p, 75 ohm
View Angle
H: 21~68 Degree, V: 16 -54 Degree
IR LED
24 pieces
IR Wavelength
850 nm
IR Distance
20~25 meters
Vandal Resistant
10 pounds
Water Resistant
IP-66
Environment
Power Requirement
DC 12V
IR on: 380mA max. /
IR off: 90mA max.
DC 12V
IR on: 410mA max. /
IR off: 120mA max.
Dimensions
145 x 110 mm (Φ x H)
Weight
1.03 kg
Operating Temperature -10 ~ 50 Degree C
5. Physical Installation
1. Use the provided wrench to loose the tamper-resistant
housing cover with screws still attached on the cover.
Note
During the installation, please take care and
avoid crash. That may cause people hurt and
this device damage.
2. Set the mounting base onto the wall or ceiling and
center it over the mounting hole, using the supplied four
retaining screws to secure the main body.
3. Set proper image by moving the camera module and set
the focus by turning the lens to the left or right direction.