PLANET CAM-IR338 - Manual

– 1 – – 2 –
– 3 – – 4 –
30-meter Infrared Camera – CAM-IR338
IR LED
Sunshield
Video Output
Power Input
Connector Description
Power Input Connect to a 12V DC power adapter.
Video Output BNC connector for analog video output.
1. Packet Contents
1. CAM-IR338 x 1
2. Quick installation guide x 1
3. Screw packet x 1
4. Bracket x 1
2. Installation
1.
Please attach the CAM-IR338 to the bracket with
screws.
2.
After the installation has been finished, please
place the camera in a suitable location.
3. Adjust the camera to the correct direction.
4. Connect video output connector to your DVR.
5.
Connect a 12V DC power adapter to the Power
Input connector.
Note
Before connecting power adapter to camera,
please make sure the power output voltage is 12V
DC (max. ±10%). If you are not sure of this part,
we suggest you use a 12V DC switching power
adapter. It can provide stable power output.
3. Specifications
Product
Model CAM-IR338
Camera
Sensor
SONY 1/3” Exview Super HAD II High
Resolution CCD
Effective Picture
Elements NTSC: 976 x 494
PAL: 976 x 582 (H x V)
Signal Processor Sony Enhanced Effio-E DSP
Lens Furnished Board Lens 6.0mm / F2.0
Minimum
Illumination
0.01 Lux with built-in IR LED
LED
IR LED 48 Units of 850nm High Power IR LED
IR Project
Distance
30 meters
Video & Audio
Horizontal
Resolution
700 TV lines
S/N Ratio More than 60 dB
White Balance Automatically (1800K ~ 10500K)
Gamma
Characteristic
0.45
Gain Control Automatically
Auto Electronic
Shutter NTSC: 1/60s~1/100,000s
PAL: 1/50s~1/110,000s
Adaptive Tone
Reproduction
ON
2D Noise
Reduction
2DNR ON
Synchronous
System
Internal, Negative Sync
Environment
Operating
Temperature -10 to 50 degrees C
(14 to 122 degrees F)
Video Output 1 Vp-p Composite Video / 75 ohms
Power Supply 12V DC, 400mA
Water Resistance IP66
Dimensions
(L x W x H)
150 x 76.8 x 77mm