PLANET WNAP-W2200 - Manual

- 1 - - 2 - - 3 -
1. Package Contents
Thank you for choosing PLANET WNAP-W2200. Before
installing the AP, please verify the contents inside the
package box.
The WNAP-W2200 should contain the following items
in the package:
WNAP-W2200 CD-ROM Screw x 2
Quick Guide
Note
If there is any item missing or damaged,
please contact the seller immediately.
2. Physical Introduction
Hardware Description
PoE
Reset Button
RJ-45 LAN Port
RJ-11 Telephone Port
USB Charging Port
PoE Port (802.3af)
4-pin Terminal Block for Telephone Wire
R
T
R
T
Y
G
R
B
B R G Y
Power LED
Charger
WNAP-W2200
Quick Installation Guide
300Mbps 802.11n Wireless
In-wall Access Point
Networking & Communication
3. Hardware Installation
STEP 1: Follow the figure below to install the WNAP-W2200.
 The Ethernet cable should not exceed 8cm in length from the end connecting to PoE port to the part that
goes through the outlet box.
1 PWR 2 3 4 5 6 7 8
1000
100
1000
100 ACT LNK
mini-GBIC
RESET
PoE Managed Switch 4 6 8 2
1 3 5 7 9 10
PoE In-Use
ACT LNK 1000
10/100
ACT LNK
Charger
To PoE Switch
To PBX
PoE Switch
Screws
Outer Cover
Ethernet Cable
(Data+Power)
Telephone Wire
To 4-pin
Terminal Block
To PoE Port
WNAP-W2200
European 86 x 86mm
Outlet Box
STEP 2: Follow the figure below to connect the network devices.
 You can charge the mobile equipment through the USB charge port while surfing the Internet.
Wireless
Connection
Laptop
Phone
USB Charging
Ethernet Cable (Data)
Telephone Pass-through
WNAP-W2200
Laptop
Smartphone/Pad
Charger