PLANET WNAP-W2200 - Manual

- 1 - - 2 - - 3 -
1. Package Contents
Thank you for choosing PLANET WNAP-W2200. Before
installing the AP, please verify the contents inside the
package box.
The WNAP-W2200 should contain the following items
in the package:
WNAP-W2200 CD-ROM Screw x 2
Quick Guide
Note
If there is any item missing or damaged,
please contact the seller immediately.
2. Physical Introduction
Hardware Description
LAN
USB Charger
RST PWR
PoE
Power LED
LAN Port
USB Charging Port
Reset Button
PoE Port (802.3af)
Power LED Description
The following table shows the meanings of Power LED
status:
LED Color Status Indication
PWR Green
On Power on
Flashing
The system is on and works
properly
Off
Neither Power nor the
device is malfunctioned
3. Hardware Installation
STEP 1: Follow the figure below to install the WNAP-W2200.
 The Ethernet cable should not exceed 8cm in length from the end connecting to PoE port to the part that
goes through the outlet box.
LAN
USB Charger
RST PWR
1 PWR 2 3 4 5 6 7 8
1000
100
1000
100 ACT LNK
mini-GBIC
RESET
PoE Managed Switch 4 6 8 2
1 3 5 7 9 10
PoE In-Use
ACT LNK 1000
10/100 ACT LNK
To PoE Switch
PoE Switch
Screws
Outer Cover
Ethernet Cable (Data+Power)
To PoE Port
WNAP-W2200
European 86 x 86mm
Outlet Box
STEP 2: Follow the figure below to connect the network devices.
 You can charge the mobile equipment through the USB charge port while surfing the Internet.
LAN
USB Charger
RST PWR
Wireless Connection
PC 2
USB Charging
Smartphone/Pad
PC 1 Ethernet Cable
(Data)
WNAP-W2200
WNAP-W2200
Quick Installation Guide
300Mbps 802.11n Wireless
In-wall Access Point
Networking & Communication