Configuration – PLANET WNAP-6300 User Manual
Page 2

– 5 –
– 6 –
6. Successful installation.
Note
Please refer to the User’s manual in CD-ROM
for more information about how to use the
external antenna with the N-type connector to
the WNAP-6300.
4. Configuration
Connect the WNAP-6300 with your PC by an Ethernet cable
plugging in LAN port of PoE injector in one side and in LAN
port of PC in the other side. Power on the WNAP-6300 by
PoE from PoE injector.
1. Assign a static IP address to your PC which should be in
the same network segment with the WNAP-6300. As the
default IP address of the WNAP-6300 is
192.168.1.1,
you may choose from 192.168.1.2 to 192.168.1.254.
Then click OK.
2. Open the web browser on your PC, key in the IP address
(192.168.1.1) of the WNAP-6300 in the address bar,
and then enter.
3. Now, you will see the log-in page of the WNAP-6300.
The default username and password are both
“admin”.
Enter them and then click Login.
Note
Please refer to the User’s manual in CD-ROM
for more information about how to set each
mode after successful log-in.