PLANET WDAP-1750AC - Manual (Page 42)

User Manual of WDAP-1750AC
-34-
Auto Channel Enable/disable auto channel selection.
Auto channel selection will automatically set the wireless channel for the
access point’s 2.4GHz frequency based on availability and potential
interference.
When disabled, select a channel manually as shown in the next table.
Auto Channel
Range
Select a range from which the auto channel setting (above) will choose a
channel.
Auto Channel
Interval
Specify a frequency for how often the auto channel setting will
check/reassign the wireless channel.
Check/uncheck the “Change channel even if clients are connected” box
according to your preference.
Channel
Bandwidth
Set the channel bandwidth:
 20MHz (lower performance but less interference)
 40MHz (higher performance but potentially higher interference)
 Auto (automatically select based on interference level).
BSS Basic Rate
Set
Set a Basic Service Set (BSS) rate: this is the transmission rate for
controlling communication frames for wireless clients.
When auto channel is disabled, select a wireless channel manually:
Object Description
Channel Interval Select a wireless channel from 1 – 11.
Channel
Bandwidth
Set the channel bandwidth:
 20MHz (lower performance but less interference),
 40MHz (higher performance but potentially higher interference)
 Auto (automatically select based on interference level).
BSS Basic Rate Set Set a Basic Service Set (BSS) rate: this is the transmission rate for
controlling communication frames for wireless clients.