PLANET WFT-801 - Manual (Page 8)

6
Chapter 6
INSTALLING THE CONVERTER
6.1 Used as a Stand-alone converter
Step 1- Turn off the power of the device in a network to which
the WFT-80X will be attached
Step 2- Ensure that there is no activity in the network
Step 3- Attach fiber cable from the WFT-80X to the fiber
network.
Step 4- TX, RX must be paired at both ends
Step 5- Attach a Cat. 5 UTP cable from the 10/100 Base- TX
network to the RJ-45 port on the WFT-80X.
Step 6- Connect the 7.5VDC power adapter to the WFT- 80X and
verify that the Power LED lights up.
Step 7- Turn on the power of the device, the TX Link and FX
Link LEDs should light when all cables are attached

NOTE:
• RJ-45 Cat 5, straight-through cable is ac-
cepted
• Please refer to Chapter 10 for more about
the wiring distance of your TP, Optic-fiber
networks.
EM_WFT8v2.indd 2004/11/5, �� 11:32 6