PLANET WFT-201 - Manual (Page 14)

12
4.2.1 System Reboot
After configuring the converter, you need to reboot the device by pressing the System
Reboot to access the new setting.
4.2.2 Factory Reset
This function is to set the device back to the factory default setting in case of the messy
setting.
4.2.3 Image Update
This function allows you to update the firmware on the media converter. Please first setup
a TFTP server and copy the firmware file to the server’s directory. Enter the server’s IP
on the "TFTP Server IP" section the firmware file name on "Image File" section then click
"Update" to update the converter’s firmware. Please regularly check PLANET web site for
any new available firmware.

NOTE:
The content of the image file will write the whole firmware of
the WFT-20x, please be sure that the image file is correct.
4.2.4 Device Status
This page shows that the device’s copper and fiber linking status.
EM-WFT20xv1.indd 2004/11/5, �� 12:01 12