PLANET VF-10x-KIT - Manual (Page 16)

1
3.3 Chassis Installation and Rack Mounting
To install the Video over fiber Converter in a 10-inch or 19-inch
Converter Chassis with standard rack, follow the instructions
described below.
Step 1: Place your Converter Chassis on a hard flat surface,
with the front panel positioned towards your front
side.
Step 2: Carefully slide in the module until it is fully and firmly
fitted into the slot of the Converter Chassis.
Figure 3-2: Insert a video over fiber converter into an available slot
Step 3: Attach a rack-mount bracket to each side of the
Converter Chassis with supplied screws attached to
the package.
Step 4: After the brackets are attached to the Converter
Chassis, use suitable screws to securely attach the
brackets to the rack.
Step 5: Proceed with the steps 4 and steps 5 of session 3.2
Stand-alone Installation to connect the video and
fiber cabling and supply power to your Converter
Chassis.