PLANET POE-151 - Manual (Page 9)

1-5
English
5.3 PoE Injector and PoE Splitter Installation
For non PoE remote device or Ethernet equipment, the PoE Injector and
PoE Splitter can runs in pair to provide DC Power for those devices, the
table below shows the model of PLANET PoE Splitters:
Model PoE Standard DC Power Out Pass-thru. Speed
POE-151S IEEE 802.3af 5V / 12V DC 10/100Mbps
POE-152S IEEE 802.3af 5V / 12V DC 10/100/1000Mbps
POE-162S IEEE 802.3at 12V / 24V DC 10/100/1000Mbps
1. Follow step 1, step 2 and step 3 of Section 5.2 for the connection.
2. Connect the UTP cable in the package from “Ethernet” of the PoE
splitter to the RJ-45 port of remote device.
3. Connect proper DC plug from “DC OUT” of PoE Splitter to the remote
device.
100 meters
DC
100Base-TX UTP
DC Power Line (DC)
AC Power Line (AC)
PoE 100Base-TX UTP with PoE
Data
Power
Data
Wireless AP
PoE
Power Data
Ethernet Switch
POE-151/152
PoE Injector
POE-151S
PoE Splitter
PoE
Ethernet+DC
PoE-IEEE 802.3af
Ready
Power in-use
DC OUT Ethernet 5V 12V
Power
DC
AC
Figure 4: Connection Architecture via PoE Injector and PoE Splitter
Note
Please ensure the PoE Splitter output voltage is correct
before applying power to remote device otherwise, it may
damage the remote device.