Extron Electronics RCP 2000 with ISS 506 - Manual (Page 4)

RCP 2000 with ISS 506 Support • Quick Start Guide
Quick Start Guide — RCP 2000 with ISS 506
Support
QS-1
Step 1
Turn the equipment off and disconnect it from the power source.
Make sure that the ISS 506 and all attached devices are turned off
and, if applicable, disconnected from the power source.
Step 2
Set the RCP 2000 on a table, podium, or other flat surface.
Step 3
If using an RS-232 connection, connect the provided RS-232 cable to
the RS-232 port on the rear panel of the ISS and to the To Switcher
port on the rear panel of the RCP 2000.
If using an IP connection, connect a network cable to the ISS 506
and the RCP 2000 rear panel Ethernet ports.
100-240V 50/60 Hz 2A MA X R/ R-Y
SD I
G/Y VID
S
B/C B-Y
H
HV /V V
HV /V
RS232 /422
1 L R
R/ R-Y 1
2 G/Y VID
B/C B-Y R/ R-Y
G/Y VID
B/C B-Y HV /V V
HV /V V
R/ R-Y 3
4 G/Y VID
B/C B-Y
VID /Y
R-Y
VID
B-Y /C
V G /Y
5
R
R-Y
LA N RESET
O
U T
P
U
T S
6 YC
B/ B-Y PR OG RAM
PREV IEW RGB/R- Y, Y , B- Y
RGB/R- Y, Y , B- Y
2 L R 3 L R 4 L R 5 L R 6 L R
I
N
P
U
T
S
L R PR EVIE W
FIXED L R PR OG RAM VAR IAB LE L R
VID
R-Y/ R
B-Y/ B Y/ G SC AN CO NVE RTED OUT PU T
C
Y
Extron
RCP 2000
Remote Control
Panel
Extron
ISS 506
Seamless
Switcher
Control System
with RS-232
Sound System
PC
DVD/VCR
TV Tuner
Document Camera Camera Codec
LCD Display
(program)
LCD Display
(preview)
Projector
PR OGRA M
H
PREVIEW
12 11 10 9 8 7 6 5 4 3 2 1 BLACK FREEZE
12 11 10 9 8 7 6 5 4 3 2 1 BLACK FREE ZE
DETA IL PICT URE CONTR OL S
SIZE CENT ER
COLO R TINT CONT
BRIGH T WIP E
DIS SOLV E CU T
DIMME R
FADE
COMMUNICATIO N Tx Rx
N A 12’ male-to-male RS-232 cable is provided with the RCP.
This cable can be used to connect the ISS 506 switcher’s
RS-232 port to the RCP 2000’s To Switcher (RS-232) port.
If you require a different length of cable, you can make
your own communication cable (see “Making an RCP
Communication Cable,” in chapter 2, “Installation”).
Additionally, you can connect the RCP 2000 to the ISS 506
via Ethernet, through a LAN, using a straight-through
cable, or directly, using an Ethernet cross-over cable.
(Ethernet cables are not provided.)