PLANET ICA-3260 - Manual (Page 51)

60fps Full HD IR Bullet IP Camera
ICA-3260
3.7.3 Maintenance
Default Settings (Including the
network setting)
Recall the device hard factory default settings. Note that
clicking this button will reset all devices’ parameters to the
factory settings (including the IP address).
Default Settings (Except the
network setting)
The unit is restarted and most current settings are reset to
factory default values. This action will not reset the
network setting.
Backup Setting
To take a backup of all of the parameters, click this
button. If necessary, it will then be possible to return to
the previous settings if settings are changed and there is
unexpected behavior.
Restore Setting
Click the “Browse” button to locate the saved backup file
and then click the “Restore Setting” button. The settings
will be restored to the previous configuration.
Firmware Upgrade The device supports new firmware upgrade.
1. Close all other application programs which are not
necessary for firmware update.
2. Make sure that only you access this device at this
moment
3. Disable Motion Detection function.
4. Select “Firmware name”
5. Select the Firmware binary file.
Make sure that the Firmware only applies to this device; once updated, it will be
burned into FLASH ROM of system.
6. Once the firmware file is selected, select “Upgrade”.
47