PLANET ICA-230 - Manual (Page 12)

12
3.5 Physical Installation
1. Connect an Ethernet cable
Connect the LAN cable on the PT Internet Camera to the network device (hub or
switch).
Note
If there has an IEEE802.3af PoE switch in your network, you can
connect the ICA-230/M230 LAN cable to this PoE switch to obtain
power. The power adapter is unnecessary when ICA-230/M230 is
connected to a PoE switch.
2. Check the LED (Front Panel)
The LED is defined to identify LAN connection type. When LAN port is connected,
the LED will be green.
3. Place the PT Internet Camera on the table or fix it onto ceiling or wall
Use screws to fix the PT Internet Camera onto the ceiling or wall. You could also
put the PT Internet Camera in the table directly.
4. Attach the power supply
Plug in power adapter and connect to power source. After power on, PT Internet
Camera will start to operate.
Note
Only use the power adapter supplied with PT Internet Camera.
Otherwise, the product may be damaged
The power adapter is unnecessary when ICA-230/M230 is connected
to a PoE switch. Otherwise, the product may be damaged when
ICA-230/M230 is connected to a PoE switch and power adapter
simultaneously.
5. Attach Speaker to PT Internet Camera (option)
If user needs not only video stream but also audio stream, then the speaker
should be attached to PT Internet Camera.