PLANET EPN-103 - Manual (Page 12)

12
3.2 Hardware Installation
Please connect the ONU to you devices as follow:
Step 1. Connecting the RJ-45 network cable.
a. Plug-in the RJ-45 cable to 10/100/1000 GE Port or 10/100
FE Ports.
b. Plug-in the other side to your host or devices.
Step 2. Connecting the fiber cable.
Before connecting, please note:
 Keep the optical connector and the optical fiber clean.
 Make sure the bending diameter of the fiber is more than 6cm.
Otherwise; the optical signal loss may be increased.
 Cover a protective cap to guard against dust and water when the
fiber is not used.
a. Remove the protective cap of the optical fiber.
b. Remove the protective cap of the ONU optical interface
(PON interface). Insert the fiber into the PON interface.
Step 3. Connecting Power Adapter.
a. Connect the power adapter to the power socket on the
ONU.
b. Insert the other end into a power outlet.
12V DC
RESET
SPEED LNK/ACT
10/100 10/100/1000 PON
Power
Power
Adapter
Laptop IPTV / Set-top-Box
10/100
10/100/
1000
OLT/
Splitter
Fiber
Figure 3-1: EPN-103 connection diagram