PLANET WGSW-52040 - Manual (Page 9)

9
6. Configuring IP Address
The IP address configuration commands for VLAN1 interface are listed below.
Before in-band management, the Managed Switch must be configured with an
IP address by out-of-band management (i.e. Console mode), the configuration
commands are as follows (All switch configuration prompts are assumed to be
“WGSW-52040” hereafter if not otherwise specified):
WGSW-52040> enable
WGSW-52040# config
WGSW-52040(config)# interface vlan 1
WGSW-52040(Config-if-Vlan1)# ip address 192.168.1.254 255.255.255.0
The previous command would apply the follow settings for the Managed Switch.
IPv4 Address: 192.168.1.254
Subnet Mask: 255.255.255.0
Figure 6-1 Configuring IPv4 address Screen
To check the current IP address or modify a new IP address for the Managed
Switch, please use the procedures as follows: