PLANET EM-MII series_v7.0.pdf User Manual
Page 21

- 21 -
4-2 Install the 10GBase-LR / SR XFP Fiber Optic Module MTB-XSR / MTB-XLR
The 10GBase-LR / SR Fiber Optic module can be installed into Planet products with 10G XFP interface.
Please refer to the following steps to install the 10GBase-LR / SR Fiber Optic module:
1. Install the XGS3-M24GX or XGS3-S4XG module into the XGS3-42000R; its 10G XFP slot supports
hot swappable feature.
2. Power on the XGS3-42000R L3 Switch and place the
Switch on a flat surface. Install the new 10GBase-LR / SR
Fiber Optic module by inserting it into the slot and sliding
it in until it stops (See
Figure 2). Press it firmly until you
hear the module snap into place. Never force, twist or bend
the 10GBase-LR / SR Fiber Optic module. The 10GBase-
LR / SR Fiber Optic module slides in smoothly and the
XGS3- 42000R L3 Switch will automatically detect the new
module.
1-Port 1
0G XFP
Modu
le
XGS3-X
FP
Figure 2: Insert the 10GBase-LR /
SR Fiber Optic Module
3. After the 10GBase-LR / SR Fiber connection is made successfully, check the LNK/ACT LED to verify
that if there is a link and a proper connection at the port.
Please refer to the Switch’s user’s manual for more about Switch or module’s management.