PLANET GSD-808HP - Manual (Page 13)

13
3.2 Rack Mounting
To install the Switch in a 19-inch standard rack, follow the instructions described
below.
Step 1: Place your POE Ethernet Switch on a hard flat surface, with the front
panel positioned towards your front side.
Step 2: Attach a rack-mount bracket to each side of the Switch with supplied
screws attached to the package. Figure 3-2 shows how to attach brackets
to one side of the Switch.
Figure 3-2: Attaching the Brackets to the Switch.
You must use the screws supplied with the mounting brackets.
Damage caused to the parts by using incorrect screws would invali-
date the warranty.
Step 3: Secure the brackets tightly.
Step 4: Follow the same steps to attach the second bracket to the opposite side.
Step 5: After the brackets are attached to the Switch, use suitable screws to
securely attach the brackets to the rack, as shown in Figure 3-3.
Figure 3-3: Mounting the Switch in a Rack
Step 6: Proceeds with the steps 4 and steps 5 of session 3.1 Desktop Installation
to connect the network cabling and supply power to your Switch.