PLANET FNSW-1600P - Manual (Page 11)

11
Note
When choosing a location, please keep in mind the environmental
restrictions discussed in Chapter 1, Section 4, in Specification.
Step 4: Connect your PoE Fast Ethernet Switch to 802.3af complied Power Devices
(PD) and other network devices.
A. Connect one end of a standard network cable to the 10/100 RJ-45 ports
at front panel of the PoE Fast Ethernet Switch.
B. Connect the other end of the cable to the network devices such as printer
servers, workstations or routers…etc.
Note
Connection to the Switch requires UTP Category 5, 5e, 6 network
cabling with RJ-45 tips. For more information, please see the
Cabling Specification in Appendix A.
Step 5: Supply power to the PoE Fast Ethernet Switch.
A. Connect one end of the power cable to the PoE Fast Ethernet Switch.
B. Connect the power plug of the power cable to a standard wall outlet.
When the PoE Fast Ethernet Switch receives power, the Power LED should remain
solid Green.
3.2 Rack Mounting
To install the PoE Fast Ethernet Switch in a 19-inch standard rack, follow the
instructions described below.
Step 1: Place your PoE Fast Ethernet Switch on a hard flat surface, with the front
panel positioned towards your front side.
Step 2: Attach a rack-mount bracket to each side of the PoE Fast Ethernet Switch
with supplied screws attached to the package. Figure 3-2 shows how to
attach brackets to one side of the PoE Fast Ethernet Switch.
Figure 3-2: Attaching the Brackets to the PoE Fast Ethernet Switch