Avago Technologies SAS 9207-4i4e Host Bus Adapter - Manual (Page 8)

Avago Technologies
- 8 -
LSI SAS 9207-4i4e PCI Express to 6Gb/s SAS HBA User Guide
October 2014 Technical Support
Figure 2 Installing an LSI SAS 9207-4i4e HBA in a PCI Express Slot
NOTE The shape, size, and locations of components on your HBA and its
bracket might vary from this illustration. The LSI SAS 9207-4i4e HBA
requires a x8 PCIe slot.
6. Secure the HBA bracket to the system’s chassis. Install the bracket screw, if applicable, or engage the system
retention mechanism to secure the HBA to the system’s chassis.
7. Connect SAS cables between the HBA and the SAS backplane, any other SATA or SAS devices, or the SAS
enclosure that contains the SATA or SAS devices. The preceding figure shows the locations of the HBA
connectors. The LSI SAS 9207-4i4e HBA has one internal x4 mini-SAS connector and one external
x4
mini-SAS connector.
For external connections, use a cable with an external mini-SAS connector (SFF-8088) on one end (to connect to
the HBA) and the appropriate connector to attach to the SATA or SAS devices on the other end.
8. Replace the cover and any power cords, and power up the system. Replace the chassis’s cover, reconnect any
power cords, and reconnect any network cables. Turn on the power.
The hardware installation of your LSI SAS 9207-4i4e HBA is complete.
8 Technical Support
For assistance installing, configuring, or running the LSI SAS 9207-4i4e HBA, contact Technical Support:
E-mail: [email protected]
Web Site: www.lsi.com/support/
?
-INI
3!3
%XTERNAL
#ONNECTOR