DE DIETRICH DTi1358DG - Manual (Page 12)

EN
12
2 / USING YOUR APPLIANCE
PASTA (function 2)
With this function you can boil and simmer water to cook pasta, for
example.
Press the B button to detect your cookware. Press OK to enter the func-
tion menu
Press the arrows until you get to function 2, then confirm (D).
Press the arrows to indicate the water quantity (0.5 to 6 litres). By
default, 2 litres are suggested. Confirm by pressing OK.
Cooking starts. A beep will sound when the water boils.
Put the pasta inside, then confirm by pressing button G of the burner
concerned.
You can adjust the power and the cooking time suggested.
A beep sounds out when cooking is finished.
N.B.: The water temperature must not be too hot or too cold at the start
of cooking as this will distort the final result.
Do not use a cast iron pan.
This function can only be used on one burner at a time.
You can also use this function to boil any food.
Note
If you are using several receptacles on the hob at the same time, try to use cooking
zones located on opposite sides. On the same side, using a booster in one zone will auto-
matically restrict the power of the other zone.
CHOOSING THE COOKING ZONE (function 3)
With this function, you can select one of four configurations (see chap-
ter: When powering on).
Add another pan:
Put your pan on the required zone and press button B to detect the
cookware’s location. A red number appears in the chosen zone. You
can now adjust the power by pressing the arrows and confirming. If you
do not select a power level, the cooking zone will automatically shut off
after a few seconds.
Moving a pan while cooking:
You can move a pan from one zone to another while cooking. Your hob
will automatically detect the position and the settings (if a number
flashes, it is necessary to confirm with the relevant G button).
N.B.: to automatically detect the position of a pan, it must be lifted to the
new cooking zone.
GRILL ZONE: This mode has been developed so that you can grill fish,
meat, vegetables, etc. on one or two vertical grills. The power of this
function is limited to 12. Once determined, it will be identical in both
zones.
Only the “Independent timer” function is active on this function.
N.B.: Your grill must not be placed in the centre of the hob.