Eagle Electronics TRIFINDER 2 - Manual (Page 35)

31
TARGETTRACK

The TriFinder 2 has the unique ability to "see" targets not only straight
down, but also to the right and left, thanks to the BroadView™ trans-
ducer. The TargetTrack
 feature shows you if the target is to the left,
right or straight down.
The BroadView transducer has three elements: left, right and down.
The TriFinder uses all three elements to display targets between the
surface and the bottom.
Targets are shown as Fish I.D. symbols. This feature also shows the depth
of the target directly above the fish symbol. In the following figure, there
are two symbols from the right element at 4 feet and 5 feet; one from the
left element at 35 feet, and one from the center element at 15 feet.
Target Track Screen.
The TargetTrack feature identifies fish symbols coming from the right
element with a "R" in front of the symbol's depth. An "L" identifies
symbols from the left element. No letter identifies fish symbols from the
center element. The bottom signal and the digital depth display are
read from the center element only.
To turn TargetTrack on, press MENU until the F
ISH
ID menu appears.
Press UP ARROW to select T RACK L&R , then press PWR to clear the menu.
To turn TargetTrack off, press MENU until the F
ISH
ID menu appears.
Press DOWN ARROW to select O FF
or any other option, then press PWR
to clear the menu.