Eagle Electronics TRIFINDER 2 - Manual (Page 19)

15
In-dash mounting template for TriFinder 2, showing dimensions.
NOTE: The figure above is
not printed to scale. A scaled template is
available for free download from our web site, www.eaglesonar.com.
If you use the supplied gimbal bracket, you may be interested in the
optional GBSA-1 swivel bracket kit. This converts the unit's gimbal
bracket to a swivel mount which can be used on the dash or overhead
mounting positions. Installation instructions for the in-dash and swivel
mounting kits are supplied with the adapter kits.
Bracket Installation
Mount the unit in any convenient location, provided there is clearance
when it’s tilted for the best viewing angle. Holes in the bracket’s base
allow wood screw or through-bolt mounting. It may be necessary to
place a piece of plywood on the back side of thin panels to reinforce the
panel. Make certain there is enough room behind the unit to attach the
power and transducer cables.
Millimeters
[Inches]
Cut on line
Top
In-Dash
Template
112
[4.40]
R 6.35
[0.25]
119
[4.68]
Hole
diameter
3.5
[0.14]
47
[1.85]
121
[4.76]
ALWAYS VERIFY DIMENSIONS