Ericsson Scan And System Portable Radios LPE-200 - Manual (Page 24)

AE/LZB 119 1902 R1A
24
FATAL_LCD_NOACK HARDWARE 40 LCD did not ack message.
FATAL_LCD_HARD_FAIL HARDWARE 41 LCD hardware is invalid.
FATAL_SCI_NOHEAP HARDWARE 50 Serial communication interface out of heap (RAM
memory) space.
FATAL_DSP_NOACK HARDWARE 60 DSP did not ack message.
FATAL_DSP_FIFOOVR HARDWARE 61 DSP RX FIFO overflow.
FATAL_DSP_BADMSG HARDWARE 62 Unknown message received from DSP.
FATAL_DSP_WRONGRESP HARDWARE 63 Unexpected response received from DSP.
FATAL_DSP_TWOACKS HARDWARE 64 Back-to-back ACKS received from DSP.
FATAL_DSP_NORESOURCE HARDWARE 65 DSP queue is full.
FATAL_BL_NOHEAP HARDWARE 91 Software memory error - Boot loader.
FATAL_BL_SCI_ATTACH HARDWARE 92 Boot loader could not attach to SCI.
FATAL_RXSIF HARDWARE 98 Phase samples are not changing.
Operational Software Fatal System Errors
Software fatal errors will automatically reset the radio. When the radio reset does not correct the problem, the radio must
be serviced. Some of the errors listed below contain additional information to help resolve the problem.
Error Name Message Code Description
RADC_PITD_ERROR TRACKING 200 Personality tracking data error. Reprogram the
tracking data.
RADC_PIHW_ERROR PERSDATA 201 Personality hardware data error. Reprogram
the personality.
RADC_FREQ_ERROR FREQDATA 202 Personality frequency data error. Reprogram
the personality.
RADC_PITD_MALLOC_ERROR SOFTWARE 203 Personality tracking data malloc error.
Reprogram the tracking data.
RADC_PITD_CKSUM_ERROR SOFTWARE 204 Personality tracking data checksum error.
Reprogram the tracking data.
DACS_MODEM_FATAL_ERROR SOFTWARE 301 Unable to correctly configure the modem for
EDACS operation. Reprogram the
personality.
DACS_RADC_FAILURE SOFTWARE 302 Power cycle the radio.
DACS_TU_PUT_CISYSMSG_ERROR SOFTWARE 303 CI message buffer is not enabled.
CONV_RADC_ERROR SOFTWARE 400 Error calling RADC function. Power cycle the
radio.
CONV_PUT_UIMSG_ERROR SOFTWARE 402 UI message buffer not enabled. Power cycle
the radio.
CONV_MODEM_RXOVR SOFTWARE 403 Conventional DIGV modem overflow.
CONV_MODEM_RXAVR SOFTWARE 404 Conventional DIGV modem underflow.
CONV_MODEM_FATAL_ERROR SOFTWARE 405 Unable to correctly configure the modem for
conventional DIGV operation
CONV_PERS_ERROR PERSDATA 407 Conventional personality error.
PI_NOPERS_ERROR PERSDATA 500 Personality data is not present. Program the
personality.
PI_CRC_ERROR PERSDATA 501 Flash personality CRC did not match
EEPROM. Reprogram the personality.
PI_DESC_CRC_ERROR PERSDATA 502 Crucial personality data has incorrect CRC.
Reprogram the personality.