Ericsson Scan And System Portable Radios LPE-200 User Manual
Page 23
AE/LZB 119 1902 R1A
23
Non-Fatal Errors
Non-fatal errors are displayed for a short period (about two seconds) then normal radio operation will resume.
Non-Fatal Errors
Error message
Description
UNKNOWN
Undocumented error.
FEAT ERR
Feature encryption error.
DSP ERR
DSP error.
NO KBANK
Attempt to keyload w/o bank storage.
NO PVT
Attempt to keyload w/o private DSP file loaded.
Special Error Codes
When the synthesizer becomes unlocked on any frequency (RX or TX), the radio will display a message and sound an
alert tone. The message will be displayed for approximately 2 seconds and the alert tone will continuously beep on and off.
During this time, the radio is trying to reload the synthesizer to get a lock condition. If the lock condition is achieved, the
unlock indications will cease. If the lock condition can not be achieved, the user will not be able to RX or TX on that
frequency. The message displayed on the radio is shown below:
ERROR CODES - SPECIFIC
Hardware Fatal System Errors
Hardware fatal errors will automatically reset the radio. When the radio reset does not correct the problem, the radio
must be serviced.
Error Name
Message
Code
Description
FATAL_SYS_TRAP
HARDWARE
0
Fatal system error trap number.
FATAL_NMI_ERROR
HARDWARE
1
NMI occurred outside of sleep.
FATAL_RAM_ERROR
HARDWARE
2
8k RAM test error.
FATAL_FLSH_CHKSUM
HARDWARE
4
Flash checksum test error.
FATAL_TG_LOAD
HARDWARE
10
TG driver failed initialization.
FATAL_DSP_LOAD
HARDWARE
11
DSP driver failed initialization.
FATAL_ABBIE_LOAD
HARDWARE
12
ABBIE driver failed initialization.
FATAL_EE_LOAD
HARDWARE
13
EEPROM driver failed initialization.
FATAL_INTOUT_LOAD
HARDWARE
15
Standard input/output driver failed initialization.
FATAL_INTIN_LOAD
HARDWARE
16
Standard input driver failed initialization.
FATAL_RADIO_LOAD
HARDWARE
17
RADIO driver failed initialization.
FATAL_MODEM_LOAD
HARDWARE
18
MODEM driver failed initialization.
FATAL_EXTIO_LOAD
HARDWARE
19
External I/O driver failed initialization.
FATAL_SCI_LOAD
HARDWARE
20
Serial communication interface driver failed
initialization.
FATAL_I2C_NOSI
HARDWARE
22
I2C failed to return SI status.