Ericsson Scan And System Portable Radios LPE-200 - Manual (Page 22)

AE/LZB 119 1902 R1A
22
ERROR CODES INTRODUCTION
This section lists all the radio errors and warnings. The radio displays errors and warnings to the user to indicate
problems that have occurred. Radio errors can occur at any time from power up to power down. Each error code in the list
includes an explanation of what went wrong and what action to take to correct the problem.
Error codes are divided into three categories:
•
Fatal operational error codes. These errors will cause the radio to reset.
•
Non-fatal operational error codes. These errors will not cause the radio to reset.
•
Radio programming error codes. These errors are displayed on the radio or the programming PC display during radio
programming.
ERROR CODE OVERVIEW
Error Code Format
The errors are displayed on the radio display as follows:
message
ERR=xxxx
Where: xxxx is the error code and message is one of the messages listed below.
Fatal Errors
Fatal errors will cause the radio to display the error message and error code and then reset to its starting operation. The
reset condition will remain until the fatal error is corrected.
Fatal Errors
Error message Description
HARDWARE BIOS errors.
SOFTWARE General software failure.
FREQDATA Frequency data error.
PERSDATA Personality errors.
NETWORK Network errors.
An example of a personality error is shown below: