beautypg.com

Thermo Pride Spirit Gas TP9C Modulating ECM 97.5% User Manual

Page 46

background image

Subject to change without notice. Published in U.S.A.

1083292-UIM-A-0114

Copyright © 2014 by Johnson Controls, Inc. All rights reserved.

Supersedes: 1031020-UIM-D-1013

York International Corp.

5005 York Drive

Norman, OK 73069

Other Jumpers

De-humidistat

Heat Pump

Zone Control

Natural Gas

LP Gas (Requires LP conversion kit)

LP Conversion Kit Installed By

Supply static

after evaporator coil (in w.c.")

Return Static (in w.c.")

before filter

Total External Static Pressure

Temperature Rise in Degrees F

Installation debris disposed of and furnace area cleaned up?

Explain operation of system to equipment owner

Blower Speed Selected

Explain the importance of regular filter replacement and equipment maintenance

Gas Side

Air Side: System External Static Pressure (Cooling Mode)

Owner Education

Additional Job Detail

Supply static

before evaporator coil (in w.c.")

Calculated input in btuh - clock the gas meter (Nat Gas Only)

Manifold Gas Pressure (in. w.c.") - furnace must be in TEST mode for setup

Inlet Gas Pressure (in. w.c.")

LP Gas Conversion Kit Part # Used

Burner flame inspected -- flames are blue and extending directly into the primary heat exchanger cells

Return Static (in w.c.")

after filter (furnace side)

Air Side: Heating

Air Side: Cooling

Air Side: Continuous Fan

Clean Up

Give owner the owner's manual provided

Gas Type

Explain thermostat use and programming (if applicable) to owner

Cycle Test

Operate the furnace through several heating cycles from the thermostat, noting and correcting any problems

Operate the furnace through continuous fan cycles from the thermostat, noting and correcting any problems

Operate the furnace through cooling cycles (as applicable), noting and correcting any problems

H (High)

MH (Med High)

ML (Med Low)

L (Low)

-10F

+10F

NOM

L (Low)

M (Med)

H (High)

YES

NO

NO

YES

NO

YES

L (Low)

ML (Med Low)

MH (Med High)

H (High)

A

B

C

ATR Setting

ADJUST Setting (ECM Models)

COOL Speed Selected

DELAY Setting (ECM Models)