Subaru Robin RGD3300H - Manual (Page 34)

– 31 –
6 Rotor (3) Use a bolt and oil as a tool for pulling
out rotor in the following procedures:
1. Pour engine oil into the center hole of
rotor shaft. Fill with oil to the shaft end.
2. Prepare a bolt with the following thread
size: M12 × P1.5
3. Apply a few turns of seal tape around
the tip of the bolt.
4. Screw the bolt into the thread of the
rotor shaft.
Do not stick out your
face over the rotor.
Step Part to remove Description Remarks Tool
SEAL TAPE
GENERATOR_GS2380.fm 31 ページ ２００７年１０月１日 月曜日 午前９時１３分