Subaru Robin EH72 LP/NG - Manual (Page 14)

- 11 -
25) ADJUST GOVERNOR SYSTEM
● Governor system is centrifugal flyweight
type . Governor weight is installed into
governor gear driven by crankshaft .
Governor weight movement is transferred
to throttle lever via governor shaft and
lever .
● Engine speed is maintained at the constant
speed by throttle valve opening and closing
operation in accordance with load condition
of engine .
(1) Push speed control lever all the way to the
high speed position and fix it by tightening
nut .
(2) Check that governor lever is pulled by
governor spring and throttle valve is fully
open .
(3) Turn governor shaft counterclockwise all
the way and tighten lock bolt to secure the
lever on the shaft .
26) BLOWER HOUSING
Attach blower housing to crankcase with
control box commonly fixed .
Connect fuel pipes onto blower housing .
BLOWER HOUSING(Front)
M6 x 14 Flange bolt : 4 pcs .
BLOWER HOUSING(Side)
M6 x 18 Flange bolt : 2 pcs .
M6 x 14 Flange bolt : 2 pcs .
GOVERNOR LEVER
GOVERNOR SHAFT
BLOWER
HOUSING
(Side)
Connect the wiring to
the electric starter.
BLOWER
HOUSING
(Front)
Tightening torque
3.9 - 5.9 N•m
(40 - 60 kgf•cm)
(2.9 - 4.3 ft•lb.)
Tightening torque
2.9 - 4.9 N•m
(30 - 50 kgf•cm)
(2.2 - 3.6 ft•lb.)