Subaru Robin EH72 LP/NG - Manual (Page 12)

- 9 -
20) COOLING FAN
Attach cooling fan onto flywheel .
M6 x 16 bolt & washer : 4 pcs .
21) THROTTLE BODY
(1) Replace the gasket of manifold with a new
one and mount the throttle body on the
intake manifold .
(2) Replace the gasket of throttle body with a
new one and mount the cleaner adapter on
the throttle body .
M6 FLANGE NUT : 4pcs .
(3) Connect the connectors from ECU to the injectors .
M6 x 30 bolt & washer : 4pcs .
(2) Connect wiring from ECU to the primary
terminal of ignition coil .
(3) Clamp the wiring harness with wire bands
to the intake manifold .
22) IGNITION COIL and WIRE CP
(1) Temporally fit ignition coil to crankcase .
Adjust air gap between ignition coil and flywheel using a thickness gauge and tighten bolts .
4-4 REASSEMBLY PROCEDURES (DIFFERENCE)
&22/,1*)$1
0%2/7DQG
:$6+(5SFV
GASKET
INJECTOR
WIRING
HARNESS #1
WIRING
HARNESS #2
THROTTLE
BODY
INTAKE
MANIFOLD
CLEANER
ADAPTER
GASKET
7+,&.1(66*$8*( ,*1,7,21&2,/
:,5(
Tightening torque
6.8 - 8.8 N•m
(70 - 90 kgf•cm)
(5.1 - 6.5 ft•lb.)
Tightening torque
6.8 - 8.8 N•m
(70 - 90 kgf•cm)
(5.1 - 6.5 ft•lb.)
Tightening torque
6.8 - 8.8 N•m
(70 - 90 kgf•cm)
(5.1 - 6.5 ft•lb.)
Ignition coil air gap
0 .3 - 0 .5 mm
(0 .012 - 0 .020 in .)