Electrolux 1600 - Manual (Page 57)

57
Installation-Site preparation
• The installation surface must be clean, dry and level. Do not install on
a deep pile carpet.
• Minor unevenness of the floor surface should never be levelled out by
laying pieces of wood, card or similar materials, but should always be
compensated for by adjusting the screw feet.
• If the appliance is installed next to a heat source (e.g. cooking appli-
ance), a heat insulating pad (87x57cm) must be placed between the
appliance and the heat source.
• Do not install the appliance in locations where the temperature may
fall below freezing.
• Please ensure that when the appliance is installed it is easily accessi-
ble for the engineer in the event of a breakdown.
Installation on a concrete base
If the unit is set up on a concrete
base, for safety reasons it is essen-
tial to fit stand plates in which the
washing machine is adjusted. The
stand plates are available from
Customer Service under the spare
parts number 645425058.