Transmission speed, Reception speed, Transmission report – TA Triumph-Adler FAX 920 User Manual
Page 21: Reception report
21
D If you send faxes to or poll faxes from fax databases, some
of these databases allow you to append the subaddress
directly to the telephone number. This will save you tele-
phone charges. First enter the telephone number of the
database and press R. Now enter the subaddress. If you are
not sure whether your fax polling service supports
subaddresses, contact the service provider.
Transmission speed
If the telephone connection used for transmission is poor,
transmission errors may occur at normal speed (14,400 bps). In
such cases it is best to reduce the speed. When you have success-
fully sent the fax, remember to set your fax machine back to the
standard speed.
1 Press MENU and 33: 31 TX SPEED.
2 Press START/COPY and use u to select the speed
you want.
3 Press START/COPY and then STOP twice.
Reception speed
If the telephone connection used for reception is poor, errors
may occur at normal speed (14,400 bps). In such cases it is best
to reduce the speed. When you have successfully received the
fax, remember to set your fax machine back to the standard
speed.
1 Press MENU and 332: 32 RX SPEED.
2 Press START/COPY and use u to select the speed
you want.
3 Press START/COPY and then STOP twice.
Transmission report
In the default setting, a transmission report is printed out only
in the event of a transmission error. However, you can change
this setting so that a transmission report is printed for every fax
transmitted, only in the event of an error or never.
1 Press MENU and 225: 25 TX REPORT.
2 Press START/COPY and use u to select ERROR,
ON or OFF.
3 Press START/COPY and then STOP twice.
Reception report
In the default setting, a reception report is printed out only in
the event of a transmission error. However, you can change this
setting so that a reception report is printed for every fax re-
ceived, only in the event of an error or never.
1 Press MENU and 226: 26 RX REPORT.
2 Press START/COPY and use u to select ERROR,
OFF or ON.
3 Press START/COPY and then STOP twice.