TA Triumph-Adler CLP 4721 - Manual (Page 27)

Printing Operation
2-2
Changing Network Interface Parameters
This printer supports TCP/IP, TCP/IP (IPv6), NetWare, AppleTalk, IPP,
SSL Server and the IPSec protocols and Security Level.
The table below shows the items required for each of the settings.
Configure the printer's network parameters as appropriate for your PC
and your network environment.
For details of the procedure, refer to the Using the Operation Panel on
page 4-1.
and security settings can be conveniently changed and checked
Menu Submenu Setting
Network TCP/IP Set. TCP/IP On/Off
IPv4
Setting
DHCP On/Off
Auto-IP On/Off
IP Address IP address
Subnet Mask IP address
Gateway
Bonjour
On/Off
IPv6
Setting
TCP/IP (IPv6) On/Off
RA (Stateless) On/Off
DHCPv6
On/Off
Security Network Security Netware Off/On
Frame type
AppleTalk On/Off
IPP On/Off
SSL
Setting
SSL On/Off
IPP over SSL On/Off
HTTPS
On/Off
IPSec On/Off
Thin Print
Setting
†
†. Thin Print is only supported in Europe (option).
Thin Print On/Off
Thin Print over
SSL
On/Off
Note After all network related settings have been done, turn the
machine OFF and ON again. This is mandatory to make the
settings effective!
IP address
Note When Embedded Web Server is used, network parameters
from your PC. For more information, refer to Embedded Web
Server on page 2-3.