Sandia 12-Gallon, 1200 PSI Hard Surface Extractor - Manual (Page 5)

(36) 1200 PSI Hard Surface Extractor 1200 PSI Hard Surface Extractor (5)
Returned Material Authorization (RMA) Procedure
Original purchaser must contact the manufacturer to follow correct RMA/warranty
procedures and must include a copy of RMA Sheet enclosed in the box with the returned
item. No returns shall be authorized unless the proper RMA procedures are followed.
It is the responsibility of the distributor to repair the customer’s equipment as soon as
possible. If the distributor does not have the facilities to repair the equipment, it may be
shipped or taken to an authorized service center for repair.
Customer must contact the manufacturer prior to working on or changing out any
parts, etc. Manufacturer must issue an RMA Sheet containing approved labor time and
replacement parts. Do not send parts or equipment back to manufacturer without an RMA
Number and approval. No labor will be paid for, nor part costs paid for or reimbursed that
have not been previously approved by manufacturer. All warranty work must be approved
and authorized to qualify and appropriate warranty procedures must be followed.
1.0 Safety Instructions
READ THIS MANUAL BEFORE USING YOUR HARD SURFACE EXTRACTOR.
KNOW THE PROPER OPERATION, CORRECT APPLICATIONS AND THE
LIMITATIONS OF THIS EQUIPMENT BEFORE USE.
Reduce the Risk of Fire, Electric Shock or Injury:
• Use only as described in this manual. Use only the attachments recommended by the
manufacturer.
• Test all outlets with an outlet tester before plugging machine into any outlet. Plug cord
into the nearest grounded outlet.
• Overloaded circuit may not always trip circuit breaker. Reduced voltage to machine
on overloaded circuit will prevent components from operating properly.
• The two (2) power cords must be plugged into separate circuits during operation.
Power Cord 1 (left side) must be on a 20 Amp circuit to use both vacuums. Power
Cord 2 (right side) must be on a 15 Amp circuit if the Auto Pump-Out is not used or a
20 Amp circuit if it is used.
• DO NOT unplug by pulling on the cord, grasp the plug. DO NOT pull unit by the
cord.
• Keep cord away from heated surfaces.
• DO NOT use if cord or plug are damaged.
• Never attempt adjustments or repairs while the machine is plugged in.
• DO NOT use outdoors, in standing water on wet surfaces.
• Pay close attention when using machine near children.
• DO NOT pick up flammable or combustible materials or use machine where they may
be present.
• DO NOT clean with solutions that are at temperatures above 140 degrees Fahrenheit.
• DO NOT allow pump to run dry. Always maintain an adequate solution level to supply
solution pump.
13.0 Base with Vacuum and Pump Components
Schematic Drawing