Sandia Auto-Fill / Auto-Dump User Manual
Auto-fill / auto-dump instruction manual

Auto-Fill / Auto-Dump Instruction Manual
By Ultimate Solutions | Sandia Products
Auto-Fill / Auto-Dump Instruction Manual
By Ultimate Solutions | Sandia Products
Ultimate Solutions Corporate Offices | 15571 Container Lane, Huntington Beach, CA 92649 | Phone: 714-901-8400 | Toll Free: 800-983-5834 | www.sandiaplastics.com
Auto-Fill and Auto-Dump Machine Upgrades
The auto-fill and auto-dump feature may be added to any of our carpet extractors
and is standard in our flood pumper machine. This feature is used to allow the
operator to continuously clean without having to fill the solution tank with clean
water and dump out the waste in the
recovery tank. This is made possible
by attaching hoses to the machine.
The following instruction manual
outlines how to set-up your machine
and maintain it all while oeprating the
unit in a safe manner.
If you have additional questions,
please contact us or an authorized
distributor.
This instruction manual covers the
auto-fill and auto-dump upgrade
feature only. Please refer to your
machine’s operating manual for a full
outline of safety instructions, set-up,
proper use, warranty information and
storage instructions.
Thank you for purchasing our auto-fill
and auto-dump feature!
1.0 Safety Instructions
READ THESE INSTRUCTIONS BEFORE SERVICING OR USING YOUR
MACHINE. KNOW THE PROPER OPERATION, CORRECT APPLICATIONS
AND THE LIMITATIONS OF THIS EQUIPMENT
BEFORE USE.
Reduce the Risk of Fire, Electric Shock or Injury:
• Use only as described your machine’s operating manual. Use only the attachments
recommended by the manufacturer.
• Test all outlets with an outlet tester before plugging machine into any outlet. Plug
cord into the nearest grounded outlet.
• Overloaded circuit may not always trip circuit breaker. Reduced voltage to
machine on overloaded circuit will prevent components from operating properly.
• If the machine includes two (2) power cords, each cord must be plugged into a
separate circuit during operation. Power Cord 1 (left side) must be on a 20 Amp
circuit to use both vacuums. Power Cord 2 (right side) must be on a 15 Amp
circuit if the Auto Pump-Out is not used or a 20 Amp circuit if it is used.
• DO NOT unplug by pulling on the cord, grasp the plug. DO NOT pull unit by the
cord.
• Keep cord away from heated surfaces.
• DO NOT use if cord or plug are damaged.
• Never attempt adjustments or repairs while the machine is plugged in.
• DO NOT use outdoors, in standing water or on wet surfaces.
• Pay close attention when using machine near children.
• DO NOT pick up flammable or combustible materials or use machine where they
may be present.
• DO NOT clean with solutions that are at temperatures above 140 degrees
Fahrenheit to avoid injury.
• DO NOT allow pump to run dry. Always maintain an adequate solution level to
supply solution pump.
• DO NOT leave machine outdoors, in extreme heat or cold. Harsh weather
elements will damage components and void warranty.
• Lift using only the appropriate handles.
• Always wear the appropriate clothing and safety equipment when operating the
machine.