Rose Electronics VISTA L-SERIES - Manual (Page 24)

18 Vista L-Series Installation and Operations Manual
Keep command
Press and release the left key, then type “K”. The Keep command
saves all settings.
Mode command
The Vista switch supports keyboard modes 1, 2 and 3 and mouse modes
7,8, and 9. To issue the “Mode” command, press and release the left
key, type “M”, then enter the mode number (1,2,3,7,8,9) followed by
.
Mode 1 - CPU Keyboard = PC Mode 1 (Some IBM’s & PS/1’s)
Mode 2 - CPU Keyboard = PC Mode 2 (Most PCs)
Mode 3 - CPU Keyboard = Most (RISC) Unix Workstations & Rose
Translator
Mode 7 - CPU Mouse = 2 Button Serial (Microsoft) (7 Bt)
Mode 8 - CPU Mouse = 2 Button Serial (Not Used) (8 Bt)
Mode 9 - CPU Mouse = 3 Button Serial (Mouse Systems)
Maximum computers
Press and release the left key, type “P”, enter the total number of
computers, and press . This command limits the number of
computers to scan. For example on an eight-port unit, if no computers
were connected to ports 7 and 8, setting maximum computers to 6 would
bypass scanning computers 7 and 8.
Typematic command
Initial factory setting = 43. Rate = 10.9 chars/sec, Delay = 500 millisec.
See Attachment F for typematic value calculations.
Mouse type
To issue the “Mouse type” command press and release the left key,
type “Q”, enter mouse type (0,1,2), and press .
Mouse type 0 = PS/2 mouse
Mouse type 1 = Serial mouse
Mouse type 2 = Wheel mouse