Rose Electronics ClassView User Manual
Page 19
CLASSVIEW INSTALLATION AND OPERATINS MANUAL
15
Typematic value command
ClassView can be configured to control the keyboard typematic rate and
delay. This setting is used to adjust the user preference of the way the
keyboard acts when holding a key down to repeat the key, such as when
moving a cursor across a line. The rate is the speed at which the keys are
sent in keys/second. The delay is the wait time in milliseconds after the key
is initially pressed, before additional keystrokes are sent. To issue the
command press and release the left Control Key, then type "A", then enter
the 1-3 digit decimal typematic value followed by {Enter]. The typematic
value is defined as shown in the below table. Use the Keep command to
save the value.
The typematic value to be used is determined by using the equation:
Typematic Value = Rate value + Delay value. Pick the desired rate in
keys/sec. (32 choices) and delay in milliseconds (4 choices) from the below
table. Add the values to the right of the desired settings. For example to use
a Rate of 16.0 keys/sec, and a 500 millisecond delay, the typematic value
would be 7 + 32 =39, so to set this value, type Ctrl A, 39 {Enter}.
Rate
Keys/sec
Rate
Value
Rate
Keys/sec
Rate
Value
Rate
Keys/sec
Rate
Value
Rate
Keys/sec
Rate
Value
30.0
0
15.0
8
7.5
16
3.7
24
26.7
1
13.3
9
6.7
17
3.3
25
24.0
2
12.0
10
8.0
18
3.0
26
21.8
3
10.9
11
5.5
19
2.7
27
20.0
4
10.0
12
5.0
20
2.5
28
18.5
5
9.2
13
4.6
21
2.3
29
17.1
6
8.6
14
4.3
22
2.1
30
16.0
7
8.0
15
4.0
23
20.
31
Table 3. Typematic rate
Delay
Value Delay Value
Delay Value
Delay Value
250
0
500
32
750
64
1000
96
Table 4. Typematic delay
Keep command
The Keep command saves the current state of the ClassView's custom
settings. These settings are scan state upon power up, scan time interval,
scan minimum and maximum ports, screen blank time interval, CPU mode,
and keyboard LED state, keyboard timeout interval, and the keyboard
typematic value. These settings are saved in non-volatile memory and
become the power-up settings. To enter the command, press and release
the left Control Key, then press "K",