RIGOL DS6000 Series - Manual (Page 32)

RIGOL
2 RP7000S User’s Guide
Probe Introduction
RP7000S is a single-ended active probe solution for high frequency application.
RP7000S uses plug-in probe head to optimize the performance and usability.
Besides, its replaceable probe tip prolongs the service life of the probe and the
spacing between probe tip and ground collar can be precisely adjusted to fit
different test point spacing. RP7000S is compatible with the auto-identification
port of
RIGOL DS6000/DS4000 series oscilloscope and can be recognized and
configured automatically by this port. Its snap-in BNC connector enables easier
connection with the oscilloscope. RP7000S provides various accessories and
options and multiple replaceable components which make it applicable to be
used in different tests and measurements.
General Inspection
1. Inspect the shipping container for damage.
If your shipping container appears to be damaged, keep the shipping
container or cushioning material until you have inspected the contents of
the shipment for completeness and have checked the probe electrically
and mechanically.
If your probe has damaged during shipping, please contact your shipper
and carrier for compensation.
RIGOL will provide no free repair or
replacement.
2. Inspect the probe.
If there is any mechanical damage or defect, or if the probe does not pass
electrical and mechanical tests, please contact your
RIGOL sales
representative.