RIGOL MSO/DS4000 Series - Manual (Page 10)

- 9 -
2． Connect the signals under test to RPL2316: users can connect
any number (≤16) of the signals under test to RPL2316 in according to
the test need. Make sure that the amplitude of the input signal should
not exceed the maximum working voltage range while connecting.
RPL2316 provides three connection methods with the signals under
test for different applications.

Method one: you can connect RPL2316 to the two rows of pins
on the device under test directly. At this point, the probe adaptor
must be connected as shown in figure 1.

Method two: you can connect the signals under test through
leads separately. At this point, the probe adaptor must be
connected as shown in figure 2. You can easily identify the
corresponding channel of each signal by the color rings on the
leads and the color information on the adaptor.