Remember to mark your g-tags – RISCO Group GT 600 User Manual
Page 35
Page
34
GT 600 601
User Manual
The readers will be allocated to a specific keypad. The G-Tag information is stored in
the keypad therefore a single keypad having two readers would only require the G-Tag
to be programmed into one of its readers
For multiple keypads with readers the sequence for programming the G-Tags would
be.
1)
Enter User Programming Mode.
2)
Choose what User Number you are using (in this case User 2) for G-Tag (A)
3)
Program G-Tag (A) onto the first reader.
4)
At the next Keypad re-enter User Programming Mode.
5)
Choose the same User Number (2).
6)
Program the same G-Tag (A) onto the second reader.
7)
Keep repeating until your G-Tag (A) is programmed onto all readers.
8)
Now move on to G-Tag (B) on User Number 3.
! Remember to mark your G-Tags !
600 601 PR600601_1_10user.qxd 25/08/2010 11:53 Page 34