RISCO Group GT 600 - Manual (Page 17)

Page 16
GT 600 601 User Manual
Programming & Deleting User Codes
(Master code only)
You will be advised by your installation company on the code length required. Under
no circumstances should the actual user code be written down.
If your installation company has given you keyswitches for the operation of your
system the last five user codes may have been reserved for use by these keyswitches.
If your engineer has indicated that some of the user numbers on your
system have been reserved you should not use them whilst
programming user codes. If you do so your system may be adversely
affected.
1) With the display showing:-
2) Enter a Master Code, the display will show:-
3) Press NO five times, the display will show:-
4) Press YES, the display will show:-
5) Enter the user number that you
wish to program followed by YES, the
display will show:-
If you need to see allocated user numbers,
press NO then keep pressing YES to view
used or spare numbers. If spare, press NO.
6) Either Enter the User Code you require
followed by YES
(
If you wish to Delete a Code enter six Zeros
followed by YES)
Or
Present your G-Tag to the Reader The display will
show:-
01 JAN 18 : 58 : 01
Do you want to . .
SET the System ?
Do you want to . .
Prog. USER CODES ?
Enter User No. - -
+YES or NO: View
Now Enter Code . .
- - - - - - Then YES
Code Type
= Master ok ?
600 601 PR600601_1_10user.qxd 25/08/2010 11:53 Page 16