beautypg.com

Step 1: installing the sim card, Step 2: connecting the router to a laptop, Initial setup and configuration steps – RISCO Group RP3G68 User Manual

Page 4

background image

4

Initial Setup and Configuration Steps

Step 1: Installing the SIM Card

A SIM card is required to establish GPRS communication.

1. Open the router cover and then insert the SIM card into its holder.

NOTE: If using IP cameras, a SIM package with a public IP is

required, with at least 3 GB per month recommended.
Otherwise, for Cloud-based 3G GPRS communication (without
using IP cameras), a public IP is not needed. Most mobile
providers offer a public IP only together with a fixed IP.

2. Remove tape from the battery terminals, install the battery in the

router, and then close up the router cover.

3. If utilizing the router only for GPRS (without WiFi or IP cameras),

go to Installing the Router-Mounting Board Assembly, page 7.

Step 2: Connecting the Router to a Laptop

Prior to installation, first connect the router to a laptop or PC, where
you view the configuration screens and define relevant settings.

1. Using the Ethernet cable, connect the network port on the router

to the network port on the laptop.

2. Connect the power cord to the micro-USB port on the router, and

then plug the other end (power adapter) into an electrical socket.

3. Press the router’s Power button for about 5 seconds. Ignore the

Power Status LED color (indicates battery level), but wait a few
seconds for the router to initialize and the other LEDs (Signal,
Network, and WiFi) to stabilize. See LED Indicators, page 15.