RISCO Group RP3G68 - Manual (Page 11)

11
Setup Prior to IP Camera & WiFi Configuration
Regardless whether wired or wireless-enabled IP cameras are used
(via a LAN or WiFi), prior to adding and configuring the IP cameras
and establishing a WiFi connection (if applicable), you first need to
set up the components for these tasks. Use any standard, multi-port
10/100 switch and Ethernet cables to connect the system as follows:
NOTE: The 10/100 switch is not provided. A single 60 cm Ethernet
cable is provided.
To set up the system before configuring IP cameras and WiFi:
1. Use Ethernet cables to connect the 10/100 switch to the following:
• Network port on the 3G router
• Network port on the laptop / PC
• Network port on the main panel’s IP module
• Network port on each IP camera
2. Power up the connected devices and wait a few minutes. A RED
network indicator light indicates an IP camera is ready for
configuring from the RISCO Installer Administrative Application
(see page 12).