RISCO Group ProSYS™ PTM User Manual

Wisdom

Page

WisDom

The Program Transfer Module (PTM) is used to

create and apply standard programming templates.
In addition, you can use the PTM on powered up,

properly functioning Main Panels, which have been

previously programmed

Note:

Some displays will differ depending on panel type and version.

Note

: If you download data from a WisDom you can

ONLY

upload to the same version and

panel type. If the wrong data is uploaded, in some circumstances, panel damage may

occur.

To create a Programming Template by copying from a programmed WisDom:

Use a programmed WisDom system to create a Programming Template to be applied to other WisDom

systems. The programming on the WisDom is ready for copying.

To copy from a programmed WisDom system into the PTM:

1. Position the PTM on J1 located on the PCB of the back panel with the red

LED FACING AWAY

from

the row of terminals

(See Fig 1).

The red LED flashes slowly.

2. Remove the J9 default jumper from its position (located next to the tamper switch on the PCB of the

front panel) on one pin and position it on both of the two pins.

3. Access the main Installer Programming menu by pressing

[9] [1]

from the regular operation

mode.

4. Without making any changes, exit the main Installer Programming menu by pressing

[0]

and press

to save. The LED on the Program Transfer Module flashes rapidly, and the keypad displays the

following:

When the LED stops flashing rapidly, the WisDom beeps and displays the following

Then the display returns to the normal operation mode display.

Cont…