Precision Digital PD6830 - Manual (Page 49)

PD6830 Pulse Input Rate/Totalizer Instruction Manual
49
Maximum & Minimum Readings (MAXIMUM & MINIMUM)
The maximum and minimum (peak & valley) readings reached by the rate are stored
in the meter since the last reset or power-up. The meter shows MAXIMUM or MINIMUM
to differentiate between run mode and max/min display. Press ENTER to remain in
Max/Min display mode. If ENTER is not pressed, the Max/Min display reading will
time out after ten seconds. The meter will return to display the actual
reading.
4065.3
MAXIMUM
3024.7
GALLONS
Run Mode
2457.7
MINIMUM
Press Up to Display and to
Toggle Between Max & Min
10 Sec Time Out
Press Enter to hold Max/Min
Press Right to Reset Max/Min
Press Menu to Exit Max/Min
Reset Meter to Factory Defaults
When the parameters have been changed in a way that is difficult to determine
what’s happening, it might be better to start the setup process from the factory
defaults.
Instructions to load factory defaults:
Enter the Advanced features menu.
Press and hold RESET button when INFO is shown.
Press ENTER when RESET DFALTS? prompt is shown
Note: If ENTER is not pressed within three seconds, the prompt will stop flashing
return to showing INFO.
INFO
RESET
DFALTS? LOADING
Press and
Hold for 5 sec
Flashing
Display
Defaults
Restored