Precision Digital PD662 - Manual (Page 26)

PD662 Loop-Powered Meter Instruction Manual
26
Reset Meter to Factory Defaults
When the parameters have been changed in a way that is difficult to
determine what’s happening, it might be better to start the setup
process from the factory defaults.
Instructions to load factory defaults:
1. Enter
the Advanced features menu. See Advanced Features Menu,
page 20.
2. Press Up arrow button to display info menu.
3. Press RIGHT arrow button when info is shown.
4. Press ENTER button when rSt is shown.
Press Enter again when display flashes rSt.
Note: If Enter is not pressed a second time within three seconds,
rSt
will stop flashing and the last ENTER press cancelled.
5. The meter goes through an initialization sequence (same as on
power-up), and loads the factory default settings.
Heater Operation
Models with the integrated heater option require no additional setup. All
heater operations are controlled automatically by the unit. An internal
temperature sensor controls the operation of the heater. The heater is
only on when required due to external temperatures.
rSt info
Press and Hold for 5 Sec
Meter Re-
Initializes
Flashing
Display
rSt
FNc